Frequency

Research shows that cellular and mitochondrial (ΔΨm) membrane potentials are strong indicators of cellular physiology. In this paper we review further research suggesting that microcurrent frequencies can positively influence both these membrane potentials. The goal of this research is to show how microcurrent might stimulate physiological potentials in order to support a healthy function of bioelectric fields of cells and organs. In the second part of the article, a study to examine the effects of microcurrent application on the body's response to electric measurements is presented, in particular to a change in voltage-current lag known as a phase angle. The test involved measuring bioimpedance of a person before and after a 30-minute application with microcurrent stimulation. Fifteen healthy subjects were examined through impedance measurements taken on one arm. The results showed a consistent increase in phase angle directly after the stimulation, confirming a widely accepted indication of health improvement on a cellular level. These results are encouraging and justify further investigations on the effect of microcurrent stimulation on the human body in relation to general cellular health and regenerative functions.

Abstmct-Experimental and theoretical studies have revealed several effects in surface-acoustic-wave chirp filters that arise from electrode reflections. One effect is that down-chirp filters have lower loss than up-chirp filters, which is shown to be caused by ...

Abstract— This paper presents an adaptive control scheme for suppressing jitter in laser beams. The variable-order adaptive controller is based on an adaptive lattice filter that implicitly identifies the disturbance statistics from real-time sensor data. The multi-channel adaptive ...

This paper describes the use of the extended Park's vector approach (EPVA) for diagnosing the occurrence of stator winding faults in operating three-phase synchronous and asynchronous motors. The major theoretical principles related with the EPVA are presented and it is shown how stator winding faults can be effectively diagnosed by the use of this noninvasive approach. Experimental results, obtained in the laboratory, corroborate that these faults can be detected, in the EPVA signature, by the identification of a spectral component at twice the fundamental supply frequency. On-site tests, conducted in a power generation plant and in a cement mill, demonstrate the effectiveness of the EPVA in the detection of stator circuit faults in large industrial motors, rated up to 5 MW

A fully automated design methodology based on nonlinear response history analysis is proposed for the optimum seismic design of reinforced concrete (RC) structures. The conventional trial-and-error process is replaced by a structural optimization algorithm that serves as a search engine capable of locating the most efficient design in terms of cost and performance. Two variations of the proposed design methodology are introduced. The first approach treats the optimum design problem in a deterministic manner, while in the second variation the optimum design is sought in the framework of a reliability-based optimization problem. The reliability-based approach seems to be a more rational procedure since more meaningful design criteria that correlate better with the performance-based design concept can be adopted. Thus, the practice of using the mean annual frequency of a limit-state being exceeded to assess the candidate designs is compared with the use of deterministic criteria. Both ...

Expanded polystyrene (EPS) geofoam seismic buffers can be used to reduce earthquake-induced loads acting on rigid retaining wall structures. A numerical study was carried out to investigate the influence of wall height; EPS geofoam type, thickness, and stiffness; and excitation record on seismic buffer performance. The numerical simulations were carried out using a verified FLAC code. The influence of parameter values was examined by computing the maximum forces on the walls, the buffer compressive strains, and the relative efficiency of the buffer system. In general, the closer the predominant frequency of excitation to the fundamental frequency of the wall model, the greater the seismic loads and buffer compression. The choice of earthquake record is shown to affect the magnitude of maximum earth force and isolation efficiency. However, when the wall response for walls 3 to 9 m in height are presented in this study in terms of isolation efficiency, the data from scaled accelerogra...

Summary form only given. Telecommunications has continued to push optical fibers towards ever-more demanding applications-such as high bit rates, dense wavelength-division multiplexing (DWDM), and long distances-and in response there has been renewed interest in alternative fiber designs to lift fundamental limitations of silica fibers. A particularly exciting departure from traditional fibers are fibers based on photonic band gaps, forbidden frequency